Hyundai Creta Struts

Not automatically. The Creta sold in South Africa as GS, then SU2, and the GS and SU2 share almost nothing visually or mechanically — check which one you have before ordering anything forward of the bulkhead. Send us the generation code off your VIN plate and we will confirm it either way before anything is dispatched.

We work backwards from the VIN: generation first, then engine family, then whether the car is pre- or post-facelift within that generation. On the Creta specifically, the GS and SU2 share almost nothing visually or mechanically — check which one you have before ordering anything forward of the bulkhead.

Push down sharply on each corner and let go. A healthy strut settles in one rebound; a worn one carries on bouncing two or three times. Back that up with the visual — oil weeping down the strut body is the end of the argument. Nose-dive under braking and clunking on rough roads point the same way.

Hyundai struts run from around R315, ranging R149 to R4,500 depending on model and specification through our supplier network. Labour is the bigger variable — a front pair takes around two hours. Note that front geometry changed within model names on Hyundai, so send the generation code with your enquiry.

Yes — both front or both rear together. A fresh strut alongside a worn one unbalances the axle and makes the car pull under braking, which is a worse outcome than the wear you started with. Budget for pairs from the outset.

Yes, and it is not an upsell. Unbolting the strut-to-knuckle joint disturbs camber, and a fresh spring changes ride height, which shifts toe. Have a four-wheel alignment done straight after fitting — skipping it wears a new set of tyres out within 10,000km.

Expect 80,000 to 120,000km before wear is noticeable, and less than that if the car lives on the coast, on gravel, or with a loaded boot. We inspect for weeping, play and the bounce test rather than replacing purely on the odometer, because the mileage figure is the least reliable part of the picture.