Hyundai H100 Brake Calipers
Brake Calipers to suit the Hyundai H100, cross-referenced against OEM specification and dispatched countrywide
What Are Hyundai H100 Brake Calipers?
Brake calipers clamp the pads onto the disc to slow your Hyundai down — fronts do most of the work on an i20 or Tucson, rears add stopping bite on the Creta and Santa Fe. SA summer heat, coastal salt and infrequent brake-fluid changes are the three things that kill them here.
Signs You Need New Brake Calipers
H100 generations and brake calipers — the short version
On the H100, Porter, Porter II and the H100 bakkie are all in circulation locally, and they do not share one parts list.Dropside, tipper and canopy conversions mean the load body is frequently not standard, so load-bed and rear-body parts have to be matched to the conversion rather than to the model.
Engine families fitted to the SA-market H100:
Disc diameter on a Hyundai tracks the derivative rather than the model — a 1.6 and a turbo version of the same car frequently run different front brakes, and N Line derivatives differ again.
Send us the derivative and whether the car has been fitted with non-standard wheels, which can rule out some caliper and disc combinations with your enquiry and we will confirm the correct brake calipers against your car before anything is dispatched.
In South Africa the H100 is mostly small-business transport that is loaded to its limit daily, which is why clutch, driveline and front-suspension parts dominate demand rather than trim or electronics. That is the wear pattern we stock and source against.
Hyundai H100 Brake Calipers — Questions We Get Asked
Will brake calipers from another H100 fit mine?
Not automatically. The H100 sold in South Africa as Porter, Porter II and the H100 bakkie, and dropside, tipper and canopy conversions mean the load body is frequently not standard, so load-bed and rear-body parts have to be matched to the conversion rather than to the model. Send us the generation code off your VIN plate and we will confirm it either way before anything is dispatched.
Which engines did the South African H100 come with?
SA-market cars ran the 2.5 and 2.6 diesels as badged on the SA derivatives. The code stamped on the block is what we work from — the badge on the boot is not reliable on its own.
How much does it cost to replace a Hyundai brake caliper?
Parts vary by model — Getz/i20 fronts are budget-friendly, while Creta and Sonata rears with electronic parking brakes cost significantly more. We source Ferodo and OEM-spec calipers through our SA supplier network. Send your VIN for a free quote on the correct caliper.
What are the symptoms of a sticking brake caliper?
A pull to one side under braking, a burnt-pad smell, excess heat from one wheel and uneven pad wear are the telltales. Hyundai Forums has a long-running thread on rear caliper slide-pin seizure — this is the exact SA-climate failure we see weekly.
Can a Hyundai brake caliper be repaired or does it need replacing?
Many can be rebuilt with a seal kit and fresh piston if the bore is clean. Pitted pistons or corroded bores mean a full replacement. On Creta and Sonata with electronic parking brakes, we usually recommend a full replacement caliper — the motor and seals are not serviced separately.
Why does my Hyundai pull to one side when braking?
Most often a sticking caliper piston or seized slide pins — the bad side barely clamps and the good side pulls the car over. Contaminated brake fluid or a collapsed flexi hose cause the same symptom. Scan for ABS codes first to rule out sensor faults.
Where can I buy Hyundai brake calipers in South Africa?
We source new, used and reconditioned calipers nationally through our SA supplier network. VIN-matching is essential because i20, Tucson and Creta calipers differ by engine size and disc diameter. Send us your VIN for a same-day quote.
Not sure which brake calipers fits your H100?
Send us your VIN or the engine code off the block and our Hyundai desk will cross-check the correct brake calipers for your exact H100 derivative.