Hyundai Veloster Struts

Not automatically. The Veloster sold in South Africa as FS, then JS, and the asymmetric three-door layout means the left and right sides are genuinely not mirror images — door, glass and trim parts must be ordered by side. Send us the generation code off your VIN plate and we will confirm it either way before anything is dispatched.

Usually, yes. The Veloster shares its Gamma GDi and T-GDi engines with the i30 and Elantra of the same era, which gives us a second catalogue to search when Hyundai-listed stock runs out. We will tell you what we are quoting rather than leaving you to guess.

Push down sharply on each corner and let go. A healthy strut settles in one rebound; a worn one carries on bouncing two or three times. Back that up with the visual — oil weeping down the strut body is the end of the argument. Nose-dive under braking and clunking on rough roads point the same way.

Hyundai struts run from around R315, ranging R149 to R4,500 depending on model and specification through our supplier network. Labour is the bigger variable — a front pair takes around two hours. Note that front geometry changed within model names on Hyundai, so send the generation code with your enquiry.

Yes — both front or both rear together. A fresh strut alongside a worn one unbalances the axle and makes the car pull under braking, which is a worse outcome than the wear you started with. Budget for pairs from the outset.

Yes, and it is not an upsell. Unbolting the strut-to-knuckle joint disturbs camber, and a fresh spring changes ride height, which shifts toe. Have a four-wheel alignment done straight after fitting — skipping it wears a new set of tyres out within 10,000km.

Expect 80,000 to 120,000km before wear is noticeable, and less than that if the car lives on the coast, on gravel, or with a loaded boot. We inspect for weeping, play and the bounce test rather than replacing purely on the odometer, because the mileage figure is the least reliable part of the picture.