Hyundai Ball Joints for Sale in South Africa

South African road surfaces punish suspension harder than the markets these cars were tuned for, and the SUVs in the range carry noticeably different rear geometry between two-wheel- and all-wheel-drive derivatives. In practice the decision in front of you is whether to replace the failed component alone or refresh the corner, since bushes and mounts around a tired damper are rarely in better condition.

The generation code and whether the car is front- or all-wheel drive. With that we can usually confirm the right part the same day, and we will tell you whether we are quoting new, aftermarket or good used stock rather than leaving you to guess.

Often not. Many of the models here — the i20, Tucson and Accent among them — use a MacPherson strut front end with lower ball joints only. Where uppers exist they mainly hold alignment and last longer, while the lowers carry the car's weight and wear first. Lower joints generally cost R800-R1,550 per side for parts, uppers R600-R1,250 where fitted, with labour adding another R500-R1,000.

Typically R1,200-R3,700 per side including parts and labour, depending on the model and whether it is an upper or a lower. A Hyundai i20 or Tucson sits at the lower end at R1,200-R1,950 per side, while a Creta or Sonata runs R2,250-R3,700. Doing both sides at once avoids paying the strip-down labour twice within a year.

Normally 80,000-120,000 km, but road surface moves that number more than mileage does. Cars living with potholes, gravel or municipal roads in poor repair can need them by 60,000 km. Hyundais working as taxis or delivery vehicles carry heavier loads more often and should be inspected at every service rather than at an interval.

Yes, and this is not a wear item you can nurse along. A ball joint that separates takes control of that wheel with it. If yours is clunking, the steering feels loose, or a workshop has already called it, keep driving to essential trips at low speed until it is fixed. It is also a roadworthy failure, so there is no version of this you can defer indefinitely.

Only if it failed through a manufacturing defect rather than wear, which is a high bar for a suspension joint. Service plans in South Africa cover scheduled maintenance and generally exclude wear-and-tear suspension components unless stated otherwise. Check your own warranty documentation rather than relying on a general answer — early failures are sometimes covered on goodwill depending on mileage and history.